Aquanami jetKayak Manual de Serviço descarregar pdf (Página 62)

Jetnami Switch Assembly Removal Procedure:

Remove kill switch

Pull out electric wires

Push out the round rubber seal of

electric wires. Apply soap or

Vaseline on the seal for easy

pushing/pulling

Stop switch, start switch and kill switch can be replaced simply by cutting off faulty one

and be replaced with new one. The wire connection must be soldered and sealed with

heat shrink tube, and covered with marine grade seal to be water proof. However the

switches and wires from the steering handle to the electric control box can be

completely replaced for better water proof as follows:

Open joy stick handle

Remove face cover

with switches

Trace the wires from handle to

control box, Disconnect the

wires from the control box

Disconnect the throttle cable

from carburetor

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 82 83

Sem comentários

Aquanami jetKayak Manual de Serviço Página 62